These metal posts are used to create a new fenceline to go around bushes, trees or even fill a gap in your fenceline. These posts come with a ground spike to secure into your lawn/soil or a post foot so it can be attached to paving/concrete. Each post will also come with a Support Leg to improve its stability. These posts also come with a Standard Bracket which can be attached to create the overhang. The post comes with predrilled holes along its length so you can attach mesh vertically to the post. Black PVC coated Wire Mesh is recommended to be used on the bottom 90cm of the post.
Whats included?
- 1x 2m Galvanised Steel Post (50x50mm), Powder Coated Black
- 1x Standard Bracket
- 2x Nuts and Bolts to attach the bracket to the post
- 1x Post Spike or Post Shoe, Hot Dipped Galvanised, Powder Coated Black
- 1x Galvanised Steel Support Leg, Powder Coated Black
- 1 x Nut and Bolt to attach the Support Leg to the post
- 1x Black Post Cap
- 1 x Polyurethane epoxy resin branding Sticker- UV and scratch resistant
Post Length: 2m, Post Width: 5cm, Post Depth: 5cm
To purchase this product please contact The Cat Proof Fence Company via email (support@TCPFC.co.site). We can discuss how many posts you require, if you require a spike or foot and how much the courier delivery would be.
Free Standing Post- Cat Proof Fence
Firstly, identify which side of the post is the 'front' by checking which side the standard bracket can be attached. This side needs to face the enclosure area.
Attach the post spike or post shoe to the bottom of the post.
If using a post spike, firstly, locate where you would like it to be installed (on grass or soil only). Rest a small piece of wood on the top of the post (to protect the paint) and using a hammer drive the post into the ground. As you hammer the post in the ground ensure the post is vertical using a level.
If using a post shoe, firstly locate where you would like it to be installed. Using a marker pen, mark on the floor where the installation holes are. If the surface is wood, screw the post shoe to the floor. You will need to use the washers provided. If the surface is concrete or paving, drill 6mm holes in the surface. Plug the holes with red wall plugs. Then screw the post shoe to the floor. You will need to use the washers provided.
Attach the support leg to the post using the nut, bolt and washer provided. The end of the support leg should rest on ground either laterally or posteriorly depending on which direction needs the most support.Insert the post cap in the top of the post.
When you attach the mesh to the post, pin the mesh to the post by attaching the standard bracket on top of the mesh. Attach the bracket to the post using the nuts and bolts provided.